• Company news

current location：home>>News>>Company news

Installation of Partial Device for Belt Filter Press

Belt filter press can be applied to a variety of conditions under the conditions of the material, high filtration efficiency, which was heavily preferred by the industry. Belt filter, frame, rubber belt, main and driven roller installation Related information:
Rack installation includes the main, driven roller installation, the top of the roller installation, under the cable roller installation and calibration rack of the level, parallelism, vertical degree. The construction units are carried out according to the following procedures:
According to the site installation space, any section of the head or tail of the rectangular frame can be used as the starting part, according to the equipment on the basis of the location of the map installed on the foundation embedded parts; with lifting equipment to rubber belt (arrow direction Point the drive roller in front of the starting part, insert the capstan or driven wheel into the inner ring surface of the rubber band and lift it to the head and tail rack; fasten the main and driven roller bearing Non-fastening state), the upper ring surface of the lifting rubber belt is connected with the connecting frame and the lower care roller, and the connecting channel and the upper tray roller frame are connected by the numbering and fixed to the connecting frame (Non-tightening state); correction rack diagonal, flatness, vertical, so that the diagonal error ≤ 5mm, flatness error ≤ 3mm, vertical error ≤ 2mm after the fastening bolts. (Flatness detection method: the top of the rack as the basis point, with ф10mm length of 25 meters filled with liquid transparent hose, measuring the length of each frame, wide horizontal level, flatness ≤ 3mm qualified).

Classification and characteristics of vacuum belt filter
Vacuum Belt filter of the three major maintenance content