• Company news

current location：home>>News>>Company news

Problems and Solutions of Debugging Process of Belt Filter Press

Belt filter press In the debugging process, the most prone to the problem is that the paper can not work properly. As the filter paper in the transmission by the frictional resistance is greater than the power, filter paper stacked in the direction of the export tank slope, can not move normally, and ultimately hinder the debugging work to continue.
The solution is: the filter paper cut, change the direction of re-connected; paper roll above the paper length detection device for the corresponding location changes; debugging to improve the level of liquid level in the tank; the debugging medium from fresh water to emulsification liquid.
Through the above solution, vacuum belt filter not only increased the system filtration capacity, improve the emulsion cleanliness, but also to achieve the desired results.

Vacuum belt filter selection guide
Application of belt filter press in sludge dewatering