• Company news

current location：home>>News>>Company news

Vacuum Belt filter precautions

Vacuum belt filter in the operation of the time, the staff need to pay attention to the following points:
1, such as hydraulic cylinder failure or leakage (including the tubing joints), after the replacement of ○-shaped seals and combined gasket.
2, vacuum belt filter filter material can not be mixed with easy to plug the feed mouth debris and hard objects, so as not to damage the filter cloth.
3, material, washing water and other valves, please press the operating procedures to open, off, do not mix.
4, electrical control system, such as failure, first cut off the power, stop repair or replacement components. Regular electrical insulation properties of the determination.
5, vacuum belt filter installed after a month should be used for oil, thoroughly clean the fuel tank. And replace the oil tank within the hydraulic oil, hydraulic oil should meet the requirements. The oil level is located on the center of the liquid level line.
6, the correct choice of filter cloth, that is, to consider the clarity of the filtrate but also take into account the filtration efficiency. Each time the end of the work must be cleaned once the filter cloth, so that no residue on the cloth. Filter cloth hardened to soften the treatment, if damaged should be promptly repaired or replaced.
7, check the belt filter filter plate sealing surface, and remove the sealing surface of the residue, so as not to work when the leakage of pulp, leakage. Pay attention to protect the sealing surface, do not crash, stand when standing as well, can reduce the deformation.

Vacuum belt filter start operation process
Vacuum belt filter operation should pay attention to matters