• Company news

current location：home>>News>>Company news

Belt filter press debugging installation and maintenance

To ensure the normal operation of the belt filter press, to extend the service life, the correct use and operation is essential. At the same time should be regularly checked, timely maintenance and care.
1, the correct choice of filter cloth, that is to consider the clarity of the filtrate but also take into account the filtration efficiency. After each work must be cleaned once the filter cloth, leaving cloth without leaving residue. Cloth to harden softening treatment, if damaged, should be promptly repaired or replaced.
2, check the sealing surface of the filter plate, and remove the residue on the sealing surface, so as to avoid leakage of work, leakage. Attention to protect the sealing surface, do not collide, stand as it is placed, can reduce the deformation.
3, electrical control system failure, first cut off the power, stop repair or replacement components. Regular electrical insulation performance measurement.
4, the new machine should be replaced after one month's use of oil, thoroughly clean the fuel tank. After six months on the tank to conduct a clean, and replace the hydraulic oil tank, hydraulic oil should meet the requirements. The oil level is above the liquid level line.
5, if the hydraulic cylinder fails or leaks (including tubing joints), see the hydraulic cylinder diagram, remove the o-ring seal and the combination gasket.
6, the temperature of the filtrate liquid is less than the rated temperature, generally <100 ℃, the feed liquid shall not be mixed with easy to block the debris and hard material inlet, so as not to damage the filter cloth.
7, liquid, washing water and other valves, please press the operating procedures on, off, do not mix.
8, the work should be done in time and as far as possible to drain the remaining liquid in the pipeline.
9, keep the machine and the surrounding clean. Timely removal of residual filtrate on the machine, cake. Piston rod smear grease regularly.
The above belt filter press debugging installation and maintenance for everyone here, for more details, please consult our website.

What is the cause of frangible framed filter press plates?
Analysis of improvement points of new sludge dewatering machine